Member Since

2008

Shanghai Reap EPS Machinery Co,ltd

 
  • sell EPS recycling machine
    1. Using in EPS recycling.2. Separate the EPS block at the joint, making the beads uniform, filled, dustless through crushing and sieving. Mix with new beads to remold and reproduce EPS products of
  • sell EPS  fluidized beds
    1. Fluidized bed is attached part of Pre-expander. warm air curtain. ; produced by high pressure fan and heat exchanger in the fluidized bed .dialyse the expanded EPS beads. 2. Improve the further
  • Sell EPS block cutting machine
    1.Its main body, welded and installed with thicken heterotype tube, can be dismantled and assembled easily.2. Horizontal, vertical and end cutting wires in the machine are used to perform the 3D
  • sell EPS  CNCshape cutting machine
    1. By controlling the synchrony running of X- axis (the transfer strap which carries EPS block) and Y- axis (the hot wire rack which carries resistor wires) to compound the graph, meanwhile use the
  • sell EPS vacuum block molding machine
    1. Use PLC programmable controller and touch screen to finish the auto cycle process of opening-closing mold, feeding, heating, heat preservation, cooling, demolding and releasing. 2. Use auto vacuum
  • sell EPS block molding machine
    1. Use PLC programmable controller and touch screen to finish the auto cycle process of opening-closing mold, feeding, heating, heat preservation, cooling, demolding and releasing. 2. Use auto vacuum
  • sell EPS continuous pre-expander
    1. EPS beads enter the fluidized beds (optional) through charging material and expansion , then go into the aging silo through transporting fan to finish their auto –cycle expansion. 2. feeding
  • sell eps batch pre-expander
    1. Foam twice or thrice (optionally) after EPS material’s once pre-expanding. For those factories whose annual output of EPS material below 2000t, only one JF-1600C batch pre-expander is necessary to
 
Page 1 of 1
Go to Page

Related Manufacturers