FEATURES
Total software upgrade
Software stored in Flash memory for later upgrade
Pre-programmed with most regionally used satellites
Uses USID
Signal strength and Bit Error Rate (Picture Quality) displayed simultaneously.
Easy reading LCD display.
Back lit display.
Up to 80 satellites may be programmed.
Bar-graph for Signal Strength
Bar-graph for BER (Picture Quality).
Satellite settings store in non-volatile EPROM
Short circuit proof on LNB output.
Internal battery powers the LNB
Works with all stander, universal, linear (DVB) and circular (DSS) polarity LNBs
Weight approx less than 2 lbs.
Size approx: 9.84in W x 4.72in H x 2.36in D (250 x 120 x 60 mm)
Set satellite's related parameter which includes LNB frequency and working voltage (mode of polarization), satellite downstream frequency, symbol ate, 22K situation etc.
AZ, EL, and PO self-calculated for providing initial dish set-ups.
Align dish without IR/D, TV and power.
In alignment process, once a satellite is found by setting related parameter, we can adjust the dish's orientation and pitching angle according to inside audible tone
Measure RF signal level, bit error rate, carrier-to-noise rate and current.
Provides special software that can be used to check local position. AZ, EL, and PO for almost all big cities around the world in alignment process of a certain satellite.
Plans can be downloaded from a certain website by RS232 port.
SPECIFICATIONS Frequency range: 950 to 2150 MHz
Input dynamic range: -65dBm to -25dBm
Symbol rate up to 2Msps to 45Msps
Input resistance: 75 Ohms
LNB supply: 13V and 18V @ 500 mA
DC power supply: DC4.8V rechargeable battery
Working time: 3 - 4 hours.
Charging time: more than 4 hours, less than 5 hours.
Power adapter input: AC110V / 60Hz / 220V / 50Hz
Power adapter output: 10.5VDC 1000mA
RS232 connecter for PC upgrade
Display: 124 x 64 wide-range temperature liquid crystal display.
Audio output: build-in speaker
Port: USB (default)
Switch: 22 KHz support
ACCESSORIES
Special power supply adapter: 1 piece
RF input connector GMHF-L9.5-JK: 1 piece
Instrument bag: 1 piece
Operator's manual: 1 piece
CD-ROM: 1 piece
Data cable: 1 piece