The ballast is the most important part of a HID xenon conversion kit.
1, lights a lamp the start test
A, input standard voltage 12.8V lightens when the light bulbshould not have the scintillation.
B, input standard voltage 12.8V lightens when the light bulb coldstart the instantaneous electric current should about 6.5;
C, input standard voltage 12.8V lightens when the light bulb hot startthe instantaneous electric current should not surpass 8A.
2, instantaneous high/low voltage charging protection test
A, the stabilizer is between 8-22v all can normally start(voltage error in the input voltage establishment to be supposed in?v within);
B, when the input voltage is lower than 8v or is higher than 22v thestabilizer to be supposed the automatic knock off (voltage error to besupposed in ?v within);
C, when the input voltage restores to below 8v above or 22v thestabilizer should be possible the self-recovery work (voltage error tobe supposed in ?v within)
3, installment protection test
5, ties hands behind the back the protection test
6, permanent power test
.
7, 1m/ inferior power failure test
8, high low temperature ambient temperature work test
9, fast starts the performance test
.
10, long time electric lamp experiment
.
11, work Temperature rise
12, quakeproof test
.
13, waterproof dustproof test
14, radiated interference test