CPB-3010 New Mobile Phone Immobilize System 24w

 

Specification:

01 TX frequency 851/869 ~ 894 MHz
02 TX frequency 925/936 ~ 965 MHz
03 TX frequency 1800 ~ 1990 MHz
04 TX frequency 2110 ~ 2170 MHz
05 Total output power:Hi 24 W ( 800: 8W, 900: 8W, 1800-1950: 8W )
Low 12 W ( 800: 4W, 900: 4W, 1800-1950: 4W )
06 Total output power include Option 3G :Hi 32W ( 800: 8W, 900:8W ,1800-1950:8W ,2100-2200:8W )
Low 16W ( 800: 4W, 900:4W ,1800-1950:4W ,2100-2200:4W )
07 Cover interface standards: AMPS,N-AMPS, NMT,TACS,GSM,CDMA,TDMA,IDEN,UMTS,3G
08 Designed to cut off wave only in the down-link band width, Therefore it doesn’t affect any Interference to base station and repeater..
09 RF output indicating of LED display
10 VSWR over protection for each modular.
11 Two fans of convection and add metal filter.
12 Option for RS-485 protocol
13 ID switch
14 TNC antenna connecter
15 IR Remote Control ( 8-10 M )
16 Automatic power switching power supply:50/60Hz/AC 100 ~ 240V transmitting to DC 24V
17 Dimension:345mm(L)×187mm(W)×58mm(H)
18 Weight:2.5 Kg ( Not include antenna )
19 Operating temperature:-10°C ~ +60°C
20 Humidity: 5% ~ 80%
21 Jamming range:Radius 50 ~ 100 M up(the signal must <-80db in the location)
22 Safety Regulation: AC Adapter UL (E190582), CSA (LR112971 Level 3)

 

Installation
01. Take the Breaker out of the packing box.
02. Plug in the antenna according to the frequencies (color).
03. Plug in the AC power and then plug in DC jack to the Jammer.
04. When the LED are on, four bands of the Jammer are activated.
Important notice
01. Before turn on the power, please make sure all antennas are correctly plug in. 02. The antennas have to plug in according to the frequency to the right connector to
prevent short circuit.
Adjust High / Low power of each band

 
Step 1 Find the sliver sticker on the bottom of the device.
Step 2 Open the sticker.
Step 3 According to the demand to switch high / low of each band.

 

Solution-Center control by RS-485